Miners lamp washers before 2000 (when they were banned) were all made from asbestos. From the 1970’s they were a composite as the two on the right of the picture. Prior to that the bottom washer was white asbestos, bottom left, and the top was blue asbestos, top left.
The ones in the picture have been safely removed from lamps and bagged and sealed for disposal.
If you plan to open a lamp please be aware and take precautions. The use,sale or distribution of asbestos has been illegal since 2000.
Since 2000 all lamps were supplied with non asbestos washers, like the beige coloured ones in the picture. The current washers we supply are green one side and black the other, for easy identification
Almost two hundred years ago, on 9 November 1815, Humphry Davy, formerly Professor of Chemistry at the Royal Institution, presented to the Royal Society the paper he later published as ‘On the Fire-damp of Coal Mines, and on Methods of Lighting the Mines so as to Prevent its Explosion’. In it, Davy described his researches into the chemical composition of “fire-damp” – the common name given to the naturally occurring mixture of flammable gases, mostly methane, that had caused several horrific mining disasters – and outlined several designs of lamp that might be used safely in the presence of the gas.
All our miners lamp middles have 6 wires or posts in brass or steel around the glass. There are five miners lamp standard wires which are fixed and there is one slide wire which as the name suggests slides up and down.
This is part of the safety lock.
To open a miners lamp;
Turn out the fuel filler flap, if it is a magnetic lock you will need a miners lamp opening magnet.
Then unscrew the vessel/base anti clockwise, as you turn you will see the slide wire drop down.
When you have removed the vessel the slide wire will have dropped far enough for you to unscrew the top of the lamp, again anti clockwise.
To close reverse the above procedure
It is possible to replace a broken slide wire, we include this as part of our lamp middle repair service.
Miners lamp standard wires are a much more complicated affair. At the bottom the wires are threaded and are screwed down into the middle base plate and treated with thread locker. At the top the wires are then pushed into the 5 holes in the brass ring or outside middle ring as we call it. They are then machine riveted. The riveting has to be done a little at a time and evenly on all 5. If not the middle will become deformed and the stress can cause it to fail when a lamp is tightened up and locked.
Miners lamps have had 5 wires around the glass since 1913. This stops a straight edge touching the glass, which could be a source of ignition for fire damp. Prior to the 1911 Act lamps normally had 4 wires and accidents had occured.
Had a guided tour of Lancashire Mining Museum at Astley Green today it is really gaining momentum, tribute to all volunteers past and present. Please follow them on Facebook and like and share their posts.